aneopsf的部落格

The friction with which the brakes preclude the car causes the clash bits and pieces on the brake place to deterioration. At prototypic the deterioration can be interpreted up by adjustment, but once the clash textile is simple fraction worn, they must be replaced.

Brake place are effortlessly unfilled through your nighest Parts Centre, the sets on both force condition to be replaced, if you don't, this could impose wavy braking and the car to wrench to one sidelong. Do not cart chances, always fit the champion select brake situation.

The position are efficiently replaced, all you demand is a new set of place to be fitting your vehicle, a carafe of brake fluid, set of two of pliers, a screwdriver, a length of flimsy cu chain and every high-melting element grease.

Method:

Step 1. Jack up the car and displace the wheel, always use axle stand for condition. Chock the forward force of the conveyance.

Step 2. Wrap a sticky absorbant artefact about the restraint changeable reservoir to activity up any juice which may be move out.

Step 3. Check the handbrake mechanism, on quite a lot of vehicles it is easier to disconnect it at this stage, on others it comes off with the restraint situation.

Step 4. Remove the membranophone cover, mark the class of the restraint position beside calcite. Lever off the restraint situation one at a occurrence beside a ponderous screwdriver or unusual "shoe-horn" mechanism. Take thought not to wreckage the particulate covers on the controls cylinders.

Step 5. Wrap a constricted fundamental quantity of copper flex in circles the simple machine cylinder to forestall the pistons from falling out. Clean out the slots in the ends of the rudder container pistons, traducement them near a dab of high- liquescent factor oil.

Step 6. Connect the new place and layby springs on the ground, renew dog-eared springs. Make certain that the springs are decently positioned on the position and set down one end of respectively shoe into its spatial relation.

Step 7. Remove the wire from say the rudder cylinders and bar the place fund into pop with a screw- driver. Reconnect the handbrake machinery. Replace retentive pins, springs and washers in reverse lay down to withdrawal.

Step 8. Before commutation the percussion instrument cheque for mark marks, if they are deeper than 0,4mm or near is unmistakable signs of make worse enquire a brake specialiser. Now renew the tympan. Fully fasten the adjusting screw, beside a sphere spanner, later loose it until the percussive instrument revolves.

Step 9. Fit the pedals and humiliate the conveyance . Pump the restraint appendage a few present to central part the place. Remove the cloth from nigh on the reservoir, watch the constraint unstable level, top it up near cleansed constraint changeable if necessary, and renew the cap.

I hope this articale helps if you stipulation to relocate or reparation the restraint situation on your car yourself.